SpeedyBee F405 WING APP
Related products
Product detailed description
Description:
- MCU STM32F405, 168 MHz, 1 MB Flash
- IMU (gyroscope and accelerometer) ICM-42688-P
- Barometer SPL006-001
- OSD chip AT7456E
- MicroSD card slot Blackbox
- UART 6 kits (USART1, USART2, USART3, UART4, UART5, UART6 (reserved for wireless telemetry board connection))
- I2C 1x Used for magnetometer, digital air speed sensor
- ADC 4x (VBAT, current, RSSI, Analog AirSpeed)
- PWM 12x (11+1 "LED "pad)
- ELRS/CRSF receiver Supported, connected to UART1
- SBUS Built-in inverter for SBUS input (UART2-RX)
- 3x LEDs for FC STATUS (blue, green) and 3.3V indicator (red) 1x RGB
- RSSI supported, named as RS .
- Supported FC INAV firmware:SpeedyBeeF405WING(default)ArduPilot.
- Weight 8.9g
SpeedyBee F405 WING PDB board
- Input voltage range 7~36V (2~6S LiPo)
- Battery voltage sensor Connection to FC VBAT board, 1K:10K (Scale 1100 in iNav, BATT_VOLT_MULT 11.0 in ArduPilot)
- Battery current sensor 90A continuous, 215A peak Current connection to FC board (Scale 195 in iNav, 50 A/V in ArduPilot)
- TVS Protective diode Yes
- FC BEC output Output 5.2V +/- 0.1V DC Continuous current 2.4A, 3A peak Designed for FC, Receiver, GPS module, AirSpeed module, Telemetry module, WS2812 LED_Strip
- VTX BEC Output 9V +/- 0.1V DC Continuous current 1.8A, 2.3A Peak voltage adjustable, 9V Default, 12V or 5V via jumper Designed for analog video transmitter, digital video transmitter, camera.
- Servo BEC output Output 4.9V +/- 0.1V DC Continuous current 4.5A, 5.5A Peak voltage adjustable, 4.9V Default, 6V or 7.2V via jumper
- Weight 11.4g
SpeedyBee F405 WING APP
- Wireless configuration (long press BOOT button for 6 seconds to switch modes) BLE mode, connect to app
- Speedybee APP
- Wi-Fi mode, connect to QGroundControl APP, Speedybee APP, MissionPlanner, etc.
Classic Bluetooth SPP mode, connect to QGroundControl APP, MissionPlanner - LED strip controller (short press BOOT to switch effects, long press 2 seconds to switch modes) 4x WS2812 LED strip connector, adjustable colors and flashing modes
- Max 5.2V 1.3A, supports approximately 70 pcs of 5050 WS2812 LED beads
- On-board battery status indicator 4x RGB indicator LEDs to display battery status by number of lights
- Weight 4.2g
