Moblite7 Walksnail 1S V3

Product detailed description

Happymodel Moblite7 Walksnail 75mm is a fully assembled whoop designed for indoor flying containing a Walksnail transmitter. The FPV drone has an integrated ExpressLRS receiver. Suitable battery capacity is 450-550mAh. The A30 connector is BT2.0 compatible.

Individual components:

FC control board SuperX HD ELRS:

• Betaflight 4.4.2 firmware is ready
• Target firmware: CRAZYBEEF4DX
• MCU:STM32F411CEU6 (100 MHz, 512K FLASH)
• Sensor: BMI270
• Power: 1-2S Lipo Lihv battery input (DC 2.8V~8.7V), only 1s input is supported for this drone
• Built-in 12A (each) Blheli_S 4in1 ESC Dshot300
• Built-in elrs UART receiver, ready for elrs v3.0, support WIFI and pass-through firmware update
• Bluejay ESC firmware ready
• Built-in 5V 1A BEC
• Built-in voltage detection

ESC controller:

• 1-2S LiPo/LiPo HV power supply.
  
• Current: 12A continuous / 15A peak (3 seconds)
  
• Support ESC-Configurator and BLHELI_S Suite configurator
  
• Factory firmware: Z-H-30 - Bluejay, 0.19, 48 kHz
  
• Default protocol: DSHOT300

Built-in ELRS receiver:

• RF frequency: 2.4 GHz
  
• Antenna: 31 mm enamelled copper wire
  
• Telemetry output Power: <12dBm
  
• Receiver protocol: CRSF
  
• Default firmware version: ExpressLRS V3.0.1
  
• Same hardware with Happymodel EP1 receiver
  
• Firmware can be updated using the ExpressLRS configurator or WIFI or Betaflight pass-through

Engines:

• Model: EX1002 20000KV
  
• Stator diameter: 10 mm
  
• Stator length: 2 mm
  
• Shaft diameter: Φ1.5 mm
  
• Weight (g): 2.5g
  
• Number of cells (Lipo): 1S only

Gemfan 1610-2 propeller:

• Weight: 0.24g
  
• Material: PC
  
• Pitch: 1 inch
  
• Support diameter: 40 mm
  
• Center hole diameter: 1.5mm

Video Transmitter:

• Model: Avatar mini 1s module
  
• Communication frequency: 5.725-5.850 GHz
  
• Transmitter Power (EIRP): FCC:<25.5dBm; CE:<14dBm; SRRC: <20dBm;MIC:<25dBm
  
• l/o Interface: JST1.O*6 (Power)JST1.O*4 (USB)
  
• Mounting holes: 25.5*25.5mm
  
• Dimensions: 33*33*6.5 mm
  
• Storage: 8G
  
• Recording: 1080p/720p
  
• Weight: 6.8g
  
• Operating temperature: -20-40℃
  
• Channels: 8
  
• Wide power input: 3.1V-5V
  
• Supported FC system: Betaflight
  
• OSD: Canvas Mode
  
• Bit Rate: 25 Mbps / 50 Mbps
  
• Latency: 22 ms average latency
  
• Antenna Connector: IPEX

FPV Camera:

• Model: Avatar nano
  
• Image sensor: 1/2.7 inch
  
• Rozlišení: 1080P/6Ofps,720P/120fps,72OP/6Ofps
  
• Ratio: 16/9 4/3
  
• Lens: 2.1mm
  
• FOV 170°
  
• Aperture: F2.0
  
• Shutter: Roller shutter
  
• Min. illumination: 0.001 Lux
  
• Weight: 3.5g
  
• Dimensions: 14*14*17mm
  
• Coaxial cable: 45mm

Package Contents:

• Mobula7 v3
  
• Gemfan 1610-2 double blade propeller replacement kit
  
• Replacement shack
  
• Propeller removal tool