Happymodel EPW6 TCXO 2.4GHz PWM receiver
Related products
The antenna is designed to be small, lightweight and easy to fit into small machines.
Product detailed description
ExpressLRS now supports direct PWM output from receivers. This receiver features PWM output for use with fixed wing aircraft, helicopters, RC cars, boats, etc.
Description:
- IPEX MHF 1/U.FL antenna connector.
- 6x PWM output
- RF frequency: 2.4 GHz (2400~2480 MHz)
- Telemetry power: 12 dBm
- Receiver protocol: PWM or CRSF
- Input Voltage: +5v-8.4v
- PCB size: 19mm x 17.5mm
- Weight: 1.49g with antenna
- Default firmware version: ExpressLRS v2.0
Firmware:
- Target option1: Generic ESP8285 6xPWM 2.4Ghz RX
PWM receiver via 1~6 PWM outputs - Target option2:HappyModel_EP_2400_RX
CRSF Serial receiver via TX and RX
Package includes:
- 1 x Happymodel EPW5 2.4GHz pwm receiver
- 2x 2.4GHz antenna
- 3 pin 2.54 mm
Binding:
Turn on the power to the EPW5 RX, wait until the green LED on the RX turns off, immediately turn off the power, and then repeat the above steps again. When the RX is powered on for the third time, the green LED will flash twice, indicating that the RX has entered pairing mode. Enter the menu of ELRS.LUA V2.0 version from your radio and then press BIND, the green LED on the RX module will start to light if the pairing is successful.
Meanings of the receiver LED status:
LED lit means successful connection or connection established; Double LED blinking means in bind mode; Slow LED blinking means no signal is connected from TX module; Fast LED blinking means in WIFI hotspot mode you can connect WIFI RX and upgrade RX firmware via web browser to 10.0.0.1 (password: expresslrs)
The antenna is designed to be small, lightweight and easy to fit into small machines.